Stand with Jesus

Going to create a tools catagory and tool usage to explain the terminal end builds on the Duet3 controller

This is my go to printer again. I just leave it on all the time, hit print and check it after a few hours , always a part. I think the full cage is...

M552 s1 m552 s0 m587 s "" P "" define the network

deciding to setup a backup board opend a can of worms, I tried to go through the update firmware using YAT and putting the files on the sd card, this ...

i had a board with 2.1 firmware this is the beginning of the update Copy the new firmware binary file to the /firmware (if RRF 3.3beta1 or later ...

I was a little deflated because I was ready to do some production runs and now this setting, one that I normally dred because your hooking up the comp...