With everything in-place and a few prints completed (4) "T" fittings for some home made landing gear for a RC project, I decided to move the unit out ...

to review: I installed the duet2 wifi on top of the ender control box, removing the ender power supply and securing it also to the top. I installed ...

; Configuration file for Duet WiFi (firmware version 3.3) ; executed by the firmware on start-up ; ; generated by RepRapFirmware Configuration Tool...

couple codes for setup m303 H0 s60 calibrate heat but also check it's performance m303 H1 s200 hotend ...

It took a couple attempts to get a complete print, it's not pretty but it has a purpose. I build raspberry pi security systems and print a stand for t...

M303 H0 S90 bed calibration

M303 H0 S90 bed calibration

M303 H0 S90 bed cal