Forums
3D Printers Introdu...
3d printers
must have upgrades
Pellet Extruders te...
 
Notifications
Clear all

Pellet Extruders technology and article: 10 Tips for Converting a 3D Printer to Pellet Extrusion

 
Page 2 / 4
must have upgrades
Last Post by admin 5 years ago
17 Posts
1 Users
0 Reactions
1,007 Views
RSS
Posts: 446
 admin
Admin
Topic starter
December 10, 2020 2:07 am
(@admin)
Member
Joined: 6 years ago
[#88]

In depth look at whats available for extruders, build types and installs.
lots of information and research to help guide you through the buy or build
process. The forum is building a hi-temp 3d printer that utilizes a pellet extruder built from plans and acquired parts.

https://makezine.com/2020/11/25/10-tips-for-converting-a-3d-printer-to-pellet-extrusion/

https://www.fabbaloo.com/blog/2018/4/17/are-pellets-better-than-filament


This topic is also published as an article here »
This topic was modified 6 years ago 2 times by admin
This topic was modified 5 years ago 6 times by admin
16 Replies
Posts: 446
 admin
Admin
Topic starter
December 12, 2020 12:00 am
(@admin)
Member
Joined: 6 years ago

Exploring more designs

1
2
3
Screen Shot 2020 12 11 at 6.58.43 PM
Screen Shot 2020 12 11 at 7.02.54 PM

This post was modified 6 years ago 2 times by admin
Reply
Posts: 446
 admin
Admin
Topic starter
December 12, 2020 12:09 am
(@admin)
Member
Joined: 6 years ago

 

Here is a scientific paper on build to test extruder

A Pellet 3D Printer: Device Design and Process Parameters Optimization

pellet science paper.pdf

 


This post was modified 6 years ago 2 times by admin
Reply
Posts: 446
 admin
Admin
Topic starter
December 12, 2020 12:55 am
(@admin)
Member
Joined: 6 years ago

 

 

 

Spitfire extruder, the Delta WASP 4070 

Screen Shot 2020 12 11 at 7.53.17 PM

Reply
Posts: 446
 admin
Admin
Topic starter
December 12, 2020 1:14 am
(@admin)
Member
Joined: 6 years ago

This is a complete guide for extruder setup including ramps and Marlin

Screen Shot 2020 12 11 at 8.11.00 PM

Excellant resource

screw info.pdf

   complete design, op specs, 

Great info for start-up

3.4 Flow Rate Output based on Screw Speed and Temperature


This post was modified 6 years ago 2 times by admin
Reply
Posts: 446
 admin
Admin
Topic starter
December 12, 2020 2:07 am
(@admin)
Member
Joined: 6 years ago

RepRap printed extruder

1

Reply
Page 2 / 4
Forum Jump:
  Previous Topic