Last seen: June 19, 2026 12:36 pm
use the command M589 as shown below. Use double quotation marks, but substitute the SSID and WiFi password for your own WorkBee network. M589 S"your...
Deciding to setup a backup board opened a can of worms, I tried to go through the update firmware using YAT and putting the files on the sd card, this...
I had a board with 2.1 firmware This is the beginning of the update Copy the new firmware binary file to the /firmware (if RRF 3.3beta1 or later ...
I was a little deflated because I was ready to do some production runs and now this setting, one that I normally dred because your hooking up the comp...
With everything in-place and a few prints completed (4) "T" fittings for some home made landing gear for a RC project, I decided to move the unit out ...
to review: I installed the duet2 wifi on top of the ender control box, removing the ender power supply and securing it also to the top. I installed ...
; Configuration file for Duet WiFi (firmware version 3.3) ; executed by the firmware on start-up ; ; generated by RepRapFirmware Configuration Tool...
couple codes for setup m303 H0 s60 calibrate heat but also check it's performance m303 H1 s200 hotend ...
It took a couple attempts to get a complete print, it's not pretty but it has a purpose. I build raspberry pi security systems and print a stand for t...
M303 H0 S90 bed calibration
M303 H0 S90 bed calibration